Canon imageCLASS MF5770 Remote Ui Manual

Also see for ImageCLASS MF5730: Basic guide Technical information Parts catalog User manual Basic guide

Protocol Settings 2-13Specifying the Network Settings25 Select [Obtain an IP Address Automatically], and specify thesetting method for the machine IP address.To use [Use DHCP], [Use BOOTP], and [Use RARP] for the IP address setting, select[On].If selecting [Off] for [Use DHCP], [Use BOOTP], and [Use RARP], the machine doesnot check the protocols.If neither DHCP, BOOTP, nor RARP can be used, the IP address specified in [IPAddress] is allocated.IMPORTANTFor this machine, in addition to direct allocation of the IP address to the machine,you can use DHCP, BOOTP, or RARP to specify the IP address. When the machineis started or reset, it checks whether DHCP, BOOTP, or RARP is being used, andthen allocates the IP address using the first available setting method.NOTE• Checking whether DHCP, BOOTP or RARP can be used takes about 1 to 2minutes; it is recommended you set unused protocols to .• Depending on whether you use DHCP, BOOTP, or RARP to allocate the IPaddress, you need to start the DHCP server, BOOTP daemon, or RARP daemon.6 Specify [IP Address], [Subnet Mask], and [Gateway Address].In [IP Address], enter the machine’s IP address. In [Subnet Mask] and [GatewayAddress], enter the subnet mask and gateway address used by the TCP/IP network.NOTEIf you are using DHCP, BOOTP, or RARP, some of the items above are not used.The values obtained from DHCP, BOOTP, or RARP are used.7 Select or for [Ethernet DriverSettings].If you want to specify the ethernet driver settings automatically, select .To specify the settings manually, select .You can specify the communication mode and ethernet type from [CommunicationType] and [Ethernet Type] when selected.8 Specify the protocol settings for printing.To use [Use Raw Print] or [Use LPD Print], select [On].