Canon imageCLASS MF5950dw Settings Manual

Also see for imageCLASS MF5950dw: Service manual Product specifications Starter Guide Basic operation guide

Contents

2-2TroubleshootingWhen an Error Message Appears“Could not connect. More than one access point was detected.”Other wireless LAN routers or access points within the connection range were detected.Wait a few moments and specify the settings again.Proceed to “Step4-A Setting the Machine Using the WPS (Push Button Mode),” on p.1-4.”WPS connection failed.”An error occurred while specifying the settings using the WPS function, resulting in a connectionfailure.Check if the wireless LAN router or access point that you are using supportsthe WPS function. ( Proceed to “Selecting a Method for Setting the Wireless LAN,” on p.1-3.)[If it is supported] Check the network connection.Proceed to ”Checking Network Connections,” on p.2-6.[If it is not supported] Set the access point manually.Proceed to “Step4-B Setting the Access Point Manually and Connecting,” on p.1-6.“Cannot find access point.”When searching for an access point, the WPS button on the wireless LAN router or access pointwas not pressed within 2 minutes.Specify the settings again.Proceed to “Step4-A Setting the Machine Using the WPS (Push Button Mode),” on p.1-4.Check the network connection if the message still appears.Proceed to “Checking Network Connections,” on p.2-6. WPS – When specifying the settings in push button modeThe machine cannot detect the wireless LAN routers or access points because there is a problemwith the network connection.Check the network connection.Proceed to “Checking Network Connections,” on p.2-6. When setting by manually selecting an access point