12345678TOPBack Previous Next3-4Table of ContentsIndexAdvanced FaxFeaturesAdvanced CopyFeaturesNetworkRemote UISystem MonitorReports and ListsTroubleshootingAppendixUsing a TCP/IP NetworkThis chapter describes the settings and proceduresnecessary to connect and use the machine with a TCP/IPnetwork.1. Network Cable Connection (See “Installing/Uninstalling Software,” in the Starter Guide.)Connect the machine to your network using the network cables.2. Interface Settings (See p. 3-5)Specify the interface settings for communication between themachine and computers on your network. To specify the settings,use:– Machine’s operation panel– Web browser (Remote UI)3. Communication Environment Setup (Seep. 3-7)Set up a configuration for communication between the machineand computers on your network. To specify the settings, use:– Machine’s operation panel– Web browser (Remote UI)4. Preparation for Protocol Settings (Seep. 3-10)Specify the machine’s IP address to make the machine and thenetwork computer can communicate before making protocolsettings. Any of the following can be used to specify the settings.– Machine’s operation panel (Additional Functions menu)– ARP/PING commands– NetSpot Device Installer (Canon utility software included in theUser Software CD)5. Protocol Settings (See p. 3-16)Specify the machine’s protocol settings. Any of the following canbe used to specify the settings.– Machine’s operation panel (Additional Functions menu)– Web browser (Remote UI)– NetSpot Device Installer (Canon utility software included in theUser Software CD)6. Setting Up a Computer for Printing/Sending aFax (See p. 3-22)Specify the settings for each computer you use for printing/sending a fax.