What Can I Do with This Machine?xxxUsers in CanadaPre-Installation Requirements for Canon Facsimile EquipmentA. LocationSupply a suitable table, cabinet, or desk. See p. 13-2 for the machine’s weight and dimensions.B. Order Information1. Provide only a single-line to touch-tone or rotary telephone set terminated with a standard4-pin modular phone plug. (Touch-tone is recommended if available in your area.)2. Order an CA11A modular jack (USOC code), which should be installed by the telephonecompany. If the CA11A jack is not present, installation cannot occur.3. Order a normal business line from your telephone company’s business representative. Theline should be a regular voice grade line or equivalent. Use one line per machine.DDD (DIRECT DISTANCE DIAL) LINE-or-IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF YOU COMMUNICATE OVERSEASCanon recommends an individual line following industry standards, e.g., the 2500 (touch tone) or 500(rotary/pulse dial) telephones. A dedicated extension off a PBX machine without “Camp On” signals is alsopermissible with the machine. Key telephone systems are not recommended because they send non-standard signals to individual telephones for ringing and special codes, which may cause a fax error.C. Power RequirementsThe power outlet should be a three-prong grounded receptacle (Single or Duplex). It shouldbe independent from copiers, heaters, air conditioners or any electric equipment that isthermostatically controlled. The rated value is 120 volts and 15 amperes. The CA11A modularjack should be relatively close to the power outlet to facilitate installation.