|
Setting NetWare ® Printer Protocol 4-11ImportantSetting NetWare ® Printer ProtocolTo perform the printer protocol settings, use your Web browser on yourcomputer with the Remote UI, the software built into the network interface.Perform the protocol settings on Web browser, after you finish setting the IPaddress for the printer on the operation panel. (Æ Setup Guide, Chapter 2,“Setting the Printer Network Information”)Setting up with a Web Browser (Remote UI)1 Start the Web Browser, enter the following URL for the Address, thenpress the Enter key.http:///Example: http://172.20.88.196/z For the Web Browser, use Netscape Navigator/Communicator 4.04 or later, or useInternet Explorer 4.01SP1 or later. However, Netscape Navigator Version 6 or lateris not compatible.z A connection through a Proxy Server cannot be used. If you are using a networkenvironment with a Proxy Server, use the “Proxies” server setting in the WebBrowser to add the printer IP address to the “Exceptions” text box (the address notused by the Proxy Server). (Performing this setting may differ, depending on thenetwork environment.)z Use the Web Browser to enable JavaScript and Cookie so these features can beused.z If more than one Remote UI is being used, then the most recently used settingsremain enabled. Starting and using only one Remote UI at a time is recommended. PreviousNext |