The edges of the paper are dirtyCause Corrective ActionThe Platen has become dirty afterborderless printing or printing onsmall paper.Open the Top Cover and clean the Platen.(See "Cleaning Inside the Top Cover.") →P.837The paper type as specified on theprinter does not match the typespecified in the printer driver.Make sure the same paper type is specified on the printer as in the printer driver.(See "Selecting the Paper Type (Roll).") →P.632(See "Selecting the Paper Type (Sheet).") →P.650Make sure the same paper type is specified in the printer driver as on the printer.1. Hold down the Stop button for a second or more to cancel printing.2. Change the paper type in the printer driver and try printing again.The paper is wrinkled or warped. Straighten out the wrinkles or curls and reload the paper. Do not use paper thathas been printed on previously.(See "Loading Rolls in the Printer.") →P.628(See "Loading Sheets in the Printer.") →P.651A cut line is printed because thefunction to reduce cutting dust hasbeen activated.If this function is not needed, deactivate CutDustReduct. through the printermenu.(See "Main Menu Settings.") →P.722The Printhead is set too low. In Head Height, choose Automatic.(See "Troubleshooting Paper Abrasion and Blurry Images (Head Height).")→P.675You are printing on heavyweightpaper or paper that curls or wrin-kles easily after absorbing ink.When printing on Heavyweight Coated Paper or other paper-based media, choosea VacuumStrngth setting of Strong or Strongest. If paper still rubs against theprinthead, try raising the Printhead by setting Head Height to Highest.(See "Adjusting the Vacuum Strength (VacuumStrngth).") →P.683(See "Troubleshooting Paper Abrasion and Blurry Images (Head Height).")→P.675When printing on CAD Tracing Paper or film-based media, choose a Vac-uumStrngth setting of Standard, Strong, or Strongest. If paper still rubsagainst the printhead, try raising the Printhead by setting Head Height to High-est.(See "Adjusting the Vacuum Strength (VacuumStrngth).") →P.683(See "Troubleshooting Paper Abrasion and Blurry Images (Head Height).")→P.675The Ejection Guide is soiled. Clean the Ejection Guide.(See "Cleaning the Printer Exterior.") →P.837The surface of the paper is dirtyCause Corrective ActionThe Paper Retainer is soiled. Clean the Paper Retainer.(See "Cleaning Inside the Top Cover.") →P.837You are using a paper thatdoes not dry easily.In the Control Panel menu, set Roll DryingTime to at least 1 min.(See "Main Menu Settings.") →P.722When paper that does not dry easily is used for printing, it may curl during printingand touch the Output Tray.Troubleshooting > Problems with the printing quality >The edges of the paper are dirty iPF81512868Downloaded from ManualsPrinter.com Manuals
