Canon mp628 Service Manual

Also see for PIXMA MP620 series: Supplementary guide On-screen manual Manual Manual Manual

Contents

However, when the ink absorber becomes full, nofurther printing can be performed unless theapplicable ink absorber is replaced.The connected digitalcamera or digital videocamera does not supportCamera Direct Printing.[2001] --- The device may be incompatible.Remove the device and check themanual supplied with the connecteddevice.Remove the cable between the camera and themachine.The remaining inkamount unknown (rawink present).[1683] U130 (Applicable ink tank icon)The remaining level of the followingink cannot be correctly detected.Replace the ink tank.An ink tank which has once been empty is installed.Replace the applicable ink tank with a new one.Printing with a once-empty ink tank can damage themachine.To continue printing without replacing the ink tank(s), press the Stop button for 5 sec. or longer todisable the function to detect the remaining inkamount. After the operation, it is recorded in themachine EEPROM that the function to detect theremaining ink amount was disabled.Ink tank not recognized. [1684] U140 The following ink tank cannot berecognized.(Applicable ink tank icon)A non-supported ink tank (an ink tank that is sold ina different region from where the machine waspurchased) is installed (the ink tank LED is turnedoff). Install the supported ink tanks.Ink tank not recognized. [1410to1419]U150 The following ink tank cannot berecognized.(Applicable ink tank icon)A hardware error occurred in an ink tank (the inktank LED is turned off). Replace the ink tank(s).No ink (no raw ink). [1688] U163 Printer detected ink out condition ofthe following ink. Replace the inktank.(Applicable ink tank icon)Replace the empty ink tank(s), and close thescanning unit (cover).Printing with an empty ink tank can damage themachine.To continue printing without replacing the ink tank(s), press the Stop button for 5 sec. or longer todisable the function to detect the remaining inkamount. After the operation, it is recorded in themachine that the function to detect the remainingink amount was disabled.Non-supported hub [2002] --- An unsupported USB hub isconnected. Remove the hub.Remove the applicable USB hub from thePictBridge (USB) connector.Time-out for the scannerdevice[2700] --- Timeout error has occurred. Press[OK].The buffer became full in the middle of scanningoperation, and 60 minutes have elapsed since then,making re-scanning unstable. Press the OK buttonto clear the error.6 / 44