Caple CR9209 Instruction Manual

Contents

Caple CR9209 Instruction Manual Manual pdf 10 page image

Instruction manual CR920910Please keep this instruction manual for future referenceELECTRICAL FEATURESOven light 2× 25 WTop inner heating element(NATURAL CONNECTION OVENS)1200WTop outer heating element(NATURAL CONNECTION OVENS)800WBottom heating element(NATURAL CONNECTION OVENS)1200WTop inner heating element (MULTIFUNCTIONAL OVENS) 2250WTop outer heating element (MULTIFUNCTIONAL OVENS) 1800WBottom heating element (MULTIFUNCTIONAL OVENS) 1250WRear heating element(MULTIFUNCTIONAL OVENS)1800WVentilator motor 15WCooling fan 18WROOM VENTILATION- The appliance should be installed into a kitchen, room or space with an air supply in accordance with BS 5440-2: 2000.Note:Regardless of room size, all rooms containing the appliance must have direct access to the outside air via a window that canbe opened or equivalent.- Where there are other fuel burning appliances in the same room, BS 5440-2: 2000 should be consulted to determine thecorrect amount of free area ventilation requirements.- The above requirements allow also for use of a gas oven and grill but if there are other gas burning appliances in the sameroom, consult a qualified engineer.GAS INSTALLATIONIMPORTANTThis appliance is supplied for use on NATURAL GAS or LPG (check the gas label attached on the appliance).- Appliances supplied for use on NATURAL GAS: they are adjusted for this gas only and cannot be used on any other gas(LPG) without modification. The appliances are manufactured for conversion to LPG.Installation and Service Regulations (United Kingdom)It is a legal requirement that all gas appliances are Installed and Serviced by a competent person in accordance with thecurrent editions of the following Standards and Regulations or those regulations appropriate to the geographical region inwhich they are to be installed:- Gas Safety (Installation and Use) Regulations- Building Regulations- British Standards- Regulations for Electrical InstallationInstallation and service of any gas product must be made by a suitably qualified and registered person competent on thetype of appliance being installed or serviced and holding a valid certificate of competence for the work being carried out.Currently the proof of competence is the Accredited Certification Scheme (ACS) or S/NVQ that has been aligned to theACS. It is also a requirement that all businesses or self employed installers are members of a class of person approved by theHealth and Safety Executive. Failure to install the appliance correctly could invalidate any manufacturers warranty and lead toprosecution under the above quoted regulation.