Cardinal 2240 Operation Manual

Cardinal 2240 Operation Manual Manual pdf 14 page image

OPERATION WITHOUT ID, Cont.Adjusting the Sample Quantity1. Press the SAMPLE key. Press the SAMPLE key againto step to the next sample quantity.Note, pressing the SAMPLE key repeatedly will causesample quantity to step in the following sequence: 5, 10,25, 50, 100, 5, 10, etc. OR3. Using the numeric keypad, key-in any desired samplevalue, then press the COUNT or ENTER key.4. Add or remove indicated sample quantity and press theCOUNT or ENTER key.5. Add or remove the pieces to be counted and read totalthe count.6. Press the ENTER key to complete the countingoperation and return to the Weight mode.Counting Out From a Container1. Place the filled container on the scale platform andpress the SAMPLE key.2. Remove the number of pieces shown on the display andpress the COUNT or ENTER key.3. Press the ZERO key to zero the count, then remove thepieces from the container and read the total numberremoved.4. Press the ENTER key to complete the countingoperation and return to the Weight mode.AccumulatorDisplaying the Accumulator.With scale in the Weight mode (Count display is blank)or in the Count mode (COUNT annunciator ON), pressthe ACCUM key (ACCUM annunicator illuminates) todisplay the contents of the accumulator. Press theACCUM key again to return to the previous display orpress the SAMPLE key to go to the sample display.Clearing the Accumulator.With scale in the Weight mode (Count display is blank)or in the Count mode (COUNT annunciator ON), pressthe ACCUM key (illuminating the ACCUM annunicator)to display the contents of the internal accumulator.Press the ZERO key to reset the accumulator to zero,then press the ACCUM key to return to the previousdisplay.13thenAdd 5Add I00.000Add 5II00.0000.000lbCOUNTSAMPLEII0 COUNTlblb0 ACCUM1 2 3 4 56 7 8 9 0SAMPLESAMPLE0 COUNT0.000 lb2583I ACCUMACCUM25831