6This section describes the use of each of the keys on the keypad of the MSB-25 Scale.4.1 KEY FUNCTIONSThe TARE key is used to enter a known tare (container) weight via thenumeric keypad. Pressing the TARE key will display zeros or the previouslyentered tare (if any) and illuminate the TARE annunciator.Pressing the ZERO key with weight on the scale, will set the gross weight tozero, and clear the tare weight, if any. If the display is in count mode, thecount will be set to zero.TAREWEIGHTZEROThe WEIGHT key is used to place the scale in the weight display mode.Pressing the WEIGHT key will display the scale weight as indicated byillumination of either the lb or lb-oz indicator. If a tare was previously enteredvia the TARE key, the net weight will be displayed and the NET annunciatorwill illuminate. If no tare has been entered, the weight displayed will be grossweight, and the GROSS annunciator will illuminate.4.0 OPERATIONThe DECIMAL key is used to enter a decimal point where desired whenkeying in a number sequence.The NUMERIC KEYS are used to enter numeric values required in thevarious operational modes and calibration procedures of the scale. The 1 and0 keys are also used to answer YES and NO questions displayed in certainoperations. The 1 and 2 keys are also used to select between scale #1 (local)and scale #2 (remote)..4170528.639CLEAR.CAUTION!!! - Dropping packages weighing more than 3pounds onto the scale platform can cause permanentdamage to the load cell.