Cargo Floor CF500 SLC Assembly Instructions Manual
Also see for CF500 SLC: ManualReplacement instructionsTechnical user's manual
                                                         | |
Contents
| 
Assembly instructions CF500 SLC Bulkmoverwww.cargofloor.com Page 11Version 01 / 12-12-2018HOISTING INSTRUCTIONSAttention!If your system has been supplied with piston rod protection, this protection needs to remain put until theend of the mounting process. It may only be removed just before you hand over the trailer to yourcustomer.Warning!It is not permitted to lift the Cargo Floor system by the cylinders, moving crossmembers, valves orpipes.You must use the hoisting points when lifting the Cargo Floor system (as shown in figure 2). You need topay particular attention that you use the right set of hoisting tools during lifting so that the bearings andconduits do not get damaged.The tilting plates mounted at the rear bridge are designed in such a way that they prevent damagesoccurring to the cylinder bottoms, conduits and valve when tilting the system onto blocks or directly ontothe chassis.The Cargo Floor system can be mounted directly on the chassis. Great care must be taken while placingthe Cargo Floor system to ensure that the system cannot slide away and cause danger and that there isabsolutely no damage caused to the system.FIG. 2Tilting plates |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine