Carrier 38AU Installation, Start-up And Service Instructions Manual

Also see for 38AU: Installation, Start-Up and Service Instructions Installation, Start-Up and Service Instructions

Carrier 38AU Installation, Start-up And Service Instructions Manual Manual pdf 45 page image

45TROUBLESHOOTING (cont)PROBLEM SOLUTIONCOMPRESSOR CYCLES ON LOW-PRESSURE SWITCHIndoor-Air Fan Running1. Liquid line solenoid valve(s) fails to open. 1. Check liquid line solenoid valve(s) for proper operation. Replace if necessary.2. Filter drier plugged. 2. Replace filter drier.3. Expansion valve power head defective. 3. Replace power head.4. Low refrigerant charge. 4. Add charge. Check low-pressure switch setting.Airflow Restricted1. Coil iced up. 1. Check refrigerant charge.2. Coil dirty. 2. Clean coil fins.3. Air filters dirty. 3. Clean or replace filters.4. Dampers closed. 4. Check damper operation and position.Indoor-Air Fan Stopped1. Electrical connections loose. 1. Tighten all connections.2. Fan relay defective. 2. Replace relay.3. Motor overload open. 3. Power supply.4. Motor defective. 4. Replace motor.5. Fan belt broken or slipping. 5. Replace or tighten belt.COMPRESSOR RUNNING BUT COOLING INSUFFICIENTSuction Pressure Low1. Refrigerant charge low. 1. Add refrigerant.2. Head pressure low. 2. Check refrigerant charge. Check outdoor-air fan thermostat settings.3. Air filters dirty. 3. Clean or replace filters.4. Expansion valve power head defective. 4. Replace power head.5. Indoor coil partially iced. 5. Check low-pressure setting.6. Indoor airflow restricted. 6. Remove obstruction.Suction Pressure High1. Heat load excessive. 1. Check for open doors or windows in vicinity of fan coil.UNIT OPERATES TOO LONG OR CONTINUOUSLY1. Low refrigerant charge. 1. Add refrigerant.2. Control contacts fused. 2. Replace control.3. Air in system. 3. Purge and evacuate system.4. Partially plugged expansion valve or filter drier. 4. Clean or replace.SYSTEM IS NOISY1. Piping vibration. 1. Support piping as required.2. Compressor noisy. 2. Replace compressor if bearings are worn.COMPRESSOR LOSES OIL1. Leak in system. 1. Repair leak.2. Crankcase heaters not energized during shutdown. 2. Check wiring and relays. Check heater and replace if defective.3. Improper interconnecting piping design. 3. Check piping for oil return. Replace if necessary.FROSTED SUCTION LINEExpansion valve admitting excess refrigerant. Adjust expansion valve.HOT LIQUID LINE1. Shortage of refrigerant due to leak. 1. Repair leak and recharge.2. Expansion valve opens too wide. 2. Adjust expansion valve.FROSTED LIQUID LINE1. Restricted filter drier. 1. Remove restriction or replace.2. Liquid line solenoid valve partially closed. 2. Replace valve.38AU