Carrier 40WAW007 Installation And Maintenance Instructions Manual

Also see for 40WAW007: Installation and maintenance instructions

Contents

6This equipment in its standard form is designed for an elec-trical supply of 208/230-1-60. Any damage to or failure ofunits caused by incorrect wiring or voltage is not covered bywarranty.Electric wiring must be sized to carry the full load ampdraw of the motor, starter, and any other controls that are usedwith the unit. See Table 2 for electrical data.Table 2 — 40WAW Electrical DataLEGENDAfter the pipe work is complete, the electrical supply can beconnected by routing the cable through the appropriate casingholes or knockouts and connecting the supply and groundcables to the unit’s power terminal.Be sure the power wiring and control wiring do not cross, asthis might cause disturbance on the controls side. See Fig. 8 forwiring diagram.WARNINGAll units must be wired strictly in accordance with the wir-ing diagram furnished with the unit. Any wiring differentfrom the wiring diagram could result in personal injury andproperty damage.CAUTIONAny original factory wiring that requires replacement mustbe replaced with wiring material having a temperature rat-ing of at least 105 C.Ensure supply voltage to the unit, as indicated on the serialplate, is not more than 10% over the rated voltage or 10%under the rated voltage.Failure to follow these recommendations may result inequipment damage.UNIT POWER SUPPLYMCA MOPD40WAW007 0.2 1540WAW009 0.2 1540WAW012 0.2 1540WAW015 0.3 1540WAW018 0.3 15MCA — Minimum Circuit AmpsMOPD — Maximum OvercurrentProtective Device