Carrier 52S Architects And Engineers' Manual

Also see for 52S series: Service technician guide Installation, operating and maintenance instructions Installation, operating and maintenance instructions Installation instructions

Carrier 52S Architects And Engineers' Manual Manual pdf 20 page image

20Accessory Retrofit Kit ForAmana/Trane SleevePart No.: AM-RETROFIT-KITThis kit contains the items that allow owners to installa 52S chassis into an Amana or Trane sleeve so thatthere is no air leakage or damage to 52S unit compo-nents. The kit includes a bracket, foam baffles, screws,side angles, a foam seal, and foam gaskets. The retro-fit kit is an accessory and must be ordered separatelyfrom the factory.The installation requires adding a bracket to the wallsleeve to ensure that the chassis will be level when it isplaced in the metal sleeve. Attach foam seal to front ofsleeve. Two foam baffles (provided in the Retrofit Kit)are placed on the outdoor condenser coil tube sheets,one baffle on each tube sheet. These baffles must beinstalled to prevent air recirculation. Foam gasketsadded to the basepan prevent water leakage.Refer to the installation instructions for completeinstallation procedures.IMPORTANT: Be sure that the foam baffles make agood seal between the grille and outdoor coil tubesheets. Improper installation of the foam baffles orneglecting to install them can result in condenser (out-door) air recirculation. This will degrade the unit’sperformance and shorten product life. Do not ignorethis step. Carrier does not assume responsibility forcosts or damages resulting from misapplication of foambaffles.ORDERING DATA (cont)Foam Baffles Attached on Outdoor Coil Tube SheetsBASEPANNOTCHLOCATION (2)GASKETS(2 EACH SIDE)Gaskets Installed onto BasepanSLEEVEINSTALLEDBRACKETATTACHEDFOAM SEALBracket Attached to Amana/Trane Metal Sleeve