Carrier AQUASMART 42WHC Installation Manual

Contents

Carrier AQUASMART 42WHC Installation Manual Manual pdf 10 page image

GB - 942 WHC/AQUASMARTE N G L I S HChangeover sensor installationMaterial supplied Changeover sensor Sensor holder clipor spring Nylon clampsAdhesive insulationChangeover sensor installation instructionsThe changeover sensor is electrically connected in the unitelectric box.During installation, the changeover sensor has to belocated on the water inlet pipe, using the sensor holder clip and nylon clamps , after removing the existing insulation.Water inletWater outletChangeover sensor mountingWhen the operation shown in the figure is finished, wrap thewhole with the adhesive insulation .Note:Make certain that changeover sensor is located on the primarycircuit (water-side before the valve).