|
Document revision historyAppController CARRIER CORPORATION ©2019Installation and Start-up Guide All rights reserved25Important changes to this document are listed below. Minor changes such as typographical or formatting errors are notlisted.Date Topic Change description Code*1/23/19 Wiring devices to the AppController'sRnet portRemoved star configuration from the first paragraph. X-TS-TS-ONew look, no content changes Added surge CAUTION to Protection specification. X-TS-AK-E-CC12/14/17 Analog outputs Corrected impedance from 500 Ohms to 2000 Ohms C-AE-ZL-E-WB2/15/17 Changed name of sensors from WS to wireless C-D1/16/17 SpecificationsWiring devices to the 'sRnet portNumber of SPT and ZS sensors clarified to 10 (5 per controlprogram)C-TS-JN-BRZS sensor overviewSPT sensor overviewSimplified. Detailed descriptions are available in specifiedmanuals. Corrected total number of ZS sensors.C-D-RDWireless sensor overviewTo install the Wireless Adapter forwireless sensorsNew Topics C-DWiring devices to the AppController'sRnet portAdded Wireless Adapter for wireless sensors C-DInput wiring specifications Added Wireless Adapter for wireless sensors C-DTo wire the controller to the network Added BACnet ARC156 connection information C-D-OCWiring for communications Changed from Wiring the AppController to the MS/TP network C-D-OCSpecifications Added BACnet ARC156 connection and Wireless Adapter forCarrier wireless sensors. Corrected SPT information.C-D-OCCoverWhat is the AppController?Changed to latest controller image. C-D6/2/16 Specifications Corrected error. Max number of third party integration pointsremoved.C-TS-RD-E2/19/16 Local access to the AppController Added USB Link wiring caution. C-TS-RD-E-JH12/2/15 Inputs Corrected error - changed 8 inputs to 6 inputs. C-TS-RR-E8/14/14 Restore factory defaults Added information on using the Factory Defaults jumper C-D-LJ-E-RDTo wire the Equipment Touch to theAppControllerAdded Caution to maintain polarity and use the power supplyonly for Carrier controllersC-TS-RD-ESpecifications Maximum number of BACnet third-party integration points usingSnap - changed to unlimited, depending on memoryPower - removed references to BACviewRnet port - added a note that number of possible ZS sensors youcan have with an Equipment Touch is 15Added Equipment Touch and removed BACviewLocal Access port - removed BACview, added Equipment TouchC-D-LJ-OWiring devices to the Rnet port Changed from "Wiring a communicating zone sensor to theAppController"Removed references to BACviewConnecting an SPT sensor Removed BACview and added Equipment TouchTo wire an Equipment Touch to theAppControllerNew topicBACview devices Removed references and topicsLocal Access to the AppController Removed BACview and added Equipment Touch* For internal use onlyDocument revision history
|
