Carrier AquaSnap 30AWH-R Installation And Operation Manual

14This wired controller can be used to configure the system setting during installation and operation. Here follow twoconfiguration sections: user parameters configuration and technical parameters configuration, please check the details in3.1 & 3.2.3.1. User parameter configurationPress the “settings” button to enter the user parameters configuration interface and press this button to page down thesetting items from 0-9 as circuit. Use the “up” or “down” button to change the value of each item.Details of the user parameters configuration table are given below: (The No. in the table below will be displayed in the leftLED tube except “0”)No. Item Descriptionj Press the “settings” button and then press “confirm” to enter date settings andthen press “up” or “down” button to change the date if necessary;k Next, press “confirm” to enter hour settings, press “up” or “down” to set the correcttime in hours;l Next, press “confirm” to enter minute settings and press “up” or “down” button toset the correct time in minutes.m Press “confirm” to confirm and exit clock settings.You can also press “settings” button to go to the next parameter.j Press and hold the “confirm” button, the icon “on” will flash, then press “confirm”,and the “on” icon will light up constantly;k Press and hold the “down” button to enter day settings, then press “up” or “down”button to select the day, press “confirm”, and the icon will remain lit up;l Press and hold the “down” button to enter hour settings, then press “up” or “down”to select the time in hours, press “confirm”.m Press and hold the “down” button to enter minute settings, then press “up” or“down” to select the time in minutes and press “confirm”.n Press and hold the “down” button to set the timer off, then press the “down”button to enter hour settings, then press “up” or “down” button to select the timein hours, and press “confirm”.o Press and hold “down” button to enter minute settings, then press “up” or “down”to select the time in minutes, press the “confirm” button to confirm;p Press and hold “confirm” to confirm and exit user settings. You can also press the“settings” button to go to the next item.This is used to record the settings if power is shutdown, and the system will recoverthe previous status once power is back.j Press “up” or “down” button to set the value;0- With power memory (default);1- Without power memory3 WIFI Status Reservedj Press the “up” or “down” button to set the value;0- Do not start air purge mode1- Start air purge modeIf choosing 0, then press the “settings” button to go to the next item;If choosing 1, then press the “confirm” button to exit the settings and unit will start3. ConfigurationClock settingsSchedule of DHW01Power memory setting2Air purge mode4