Carrier AquaSnap 30AWH-R Installation And Operation Manual

15the air purge mode; during the air purge mode, wired controller will be displayed“PA”, and only the “ON/OFF” button are valid to exit this mode.j Press “up” or “down” button to set the value;k Then press “confirm” button to confirm and exit user settings or you can alsopress “settings” button to go to the next item.0 - Home; 1- Eco; 2- AwayThis is used to set up night mode for low noise during the night-time.Press “up” or “down” button to set the value:0 - Without night mode1 - With night modeIf choosing 0, press “confirm” and exit user settings or you can also press “settings”button to go to the next item;If choosing 1, then follow the steps below:j Press “confirm” button to set the start timer setting, then press “up” or “down”button to set the time in hours;k Press “confirm” to enter minute setting, then press “up” or “down” button to setthe time in minutes;l Press the “confirm” button to enter the stop timer setting, then press “up” or“down” button to set the time in hours;m Press “confirm” button to enter minute settings, then press “up” or “down” buttonto set the time in minutes;n Next, press “confirm” to confirm and exit user settings or you can also press the“settings” button to go to the next item.Anti-legionella Press the “up” or “down” button to set the value;temperature setting Temperature range: 60-700C, default as 600C.j Press and hold “confirm” button to enter day settings, press “down” button to setthe day, then press the “confirm” button to confirm, after which the icon of the daywill remain lit up.k Press and hold the “down” button to enter hour settings, then press “up” or “down”button to select the time in hour, press the “confirm” button to confirm.l Press and hold the “down” button to enter minute settings, then press “up” or“down” button to select the time in minutes and press “confirm”.m Press and hold the “confirm” button to confirm and exit user settings or you canalso press “settings” button to go to the next item.Used to lock the button of wired controller in case children touch by mistake; doublepress the “settings” button to unlock.j Press the “up” or “down” button to set the value;k Next, press the “confirm” button to confirm and exit user settings or you can alsopress the “settings” button to go to the next item.0- Without lock1- With lockEnglish3. ConfigurationOccupancy modesetting5Night mode setting6Anti-legionella timer starts8Lock of wired controller97