Carrier P1 Plus series Owners And Installation Manual

Carrier P1 Plus series Owners And Installation Manual Manual pdf 19 page image

16UNIT OPERATIONThe air discharge direction can be controlled to swing up and down and can be fixed at a preferred position or at automatic position by the remote control.• If you select the flap position using the FLAP button in the remote control, the flap in the unitwill move to that position automatically.Once you select the position, the unit remembers that position and whenever you turn onthe unit, the flap will be positioned to that position.• If you select SWING, the flap will swing up and down. In the COOL, DRY and FAN mode,the flap will swing in the cool range. In the HEAT mode, the flap will swing in the heat range.• If you select AUTO, the flap will position itself to the preset position according to the operation mode.CLOSERemote Control Auto PositionSwing RangeIf you want to adjust the direction of the discharge air left or right, adjust the vertical louver withthe handle after opening the flap.COOLHEATCOOLHEAT• Always use the remote control to adjust the flap position,otherwise it may cause abnormal operation.Please turn off the unit and turn it on again when youmanually adjust the flap out of range.NOTE1234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234512345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123451234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234512345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345DISCHARGE AIR LOUVER CONTROLUp and Down ControlLeft and Right Control• Please do not fix the flap at position for a long time, because this position minimizes air circulation resulting in uneven room temperature.• Do not adjust the flap by the hand during SWING operation because it may damage the air swing mechanism.• If you want maximum cooling or heating capacity, please set flap at position .NOTEHANDLEAUTOSWING2004.6.11, 3:7 PMPage 16