Carrier P1 Plus series Owners And Installation Manual

Carrier P1 Plus series Owners And Installation Manual Manual pdf 28 page image

25• It is best for the piping to go through the wall behind the unit. So that the unit hides the pipes.• For this method of installation, make a 65mm diameter hole in the wall at either point L or R. ( Figure. 5 )• Drill a hole at a slope so that the outside end is lower ( 5-10mm ) than the insideend to ensure good drainage.• Cut the Wall Sleeve to match the wall thickness and to pass the pipe through thehole. ( Figure. 6 )185 500 105• Remove the knock-out in the unit and pass the pipes through the wall.• The pipe should slope downward and away from the unit to ensure good drainage.123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123412345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012341234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123412345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012342) Making the Wall Penetration for the Interconnecting PipingRear PipingFigure 5Side or Bottom PipingFigure 65~10mm lowerINDOOR UNIT INSTALLATIONIndoor side Outdoor side2004.6.11, 3:15 PMPage 25