Carrier PHD4 Series Installation Instruction

Also see for PHD4 Series: Installation instructions

PHD4 Series K and WPH4 Series K: Installation InstructionManufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.9A09051NOTE: See dimensional drawing for corner weight distribution.Fig. 7 – Rigging WeightsStep 4 – Rig and Place UnitRigging and handling of this equipment can be hazardous for manyreasons due to the installation location (roofs, elevated structures, etc.).Only trained, qualified crane operators and ground support staff shouldhandle and install this equipment.When working with this equipment, observe precautions in the literature,on tags, stickers, and labels attached to the equipment, and any othersafety precautions that might apply.Training for operators of the lifting equipment should include, but not belimited to, the following:1. Application of the lifter to the load, and adjustment of the lifts toadapt to various sizes or kinds of loads.2. Instruction in any special operation or precaution.3. Condition of the load as it relates to operation of the lifting kit, suchas balance, temperature, etc.Follow all applicable safety codes. Wear safety shoes and work gloves.InspectionPrior to initial use, and at monthly intervals, all rigging shackles, clevispins, and straps should be visually inspected for any damage, evidenceof wear, structural deformation, or cracks. Particular attention should bepaid to excessive wear at hoist hooking points and load support areas.Materials showing any kind of wear in these areas must not be used andshould be discarded.1. Leave top shipping skid on the unit for use as a spreader bar toprevent the rigging straps from damaging the unit. If the skid is notavailable, use a spreader bar of sufficient length to protect the unitfrom damage.RIGGING WEIGHTS (SMALL CABINET) RIGGING WEIGHTS (LARGE CABINET)Unit 24 30 Unit 36 42 48 60lb kg lb kg lb kg lb kg lb kg lb kgRigging Weight 343 155.6 376 170.6 Rigging Weight 420 190.6 440 199.6 440 199.6 510 231.4WARNING!PERSONAL INJURY OR PROPERTY DAMAGEHAZARDFailure to follow this warning could result in personal injury, death orproperty damage.When installing the unit on a rooftop, be sure the roof will support theadditional weight.WARNING!UNIT FALLING HAZARDFailure to follow this warning could result in personal injury or death.Never stand beneath rigged units or lift over people.WARNING!PROPERTY DAMAGE HAZARDFailure to follow this warning could result in personal injury or death.When straps are taut, the clevis should be a minimum of 36 in. (914mm) above the unit top cover.