Carrier PY5G B Series Installation Instructions Manual

PY5G--B: Installation InstructionsManufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.10Step 6 – Connect Condensate DrainNOTE: When installing condensate drain connection be sure to complywith local codes and restrictions.This unit disposes of condensate water through a 3/4 in. NPT fittingwhich exits through the base on the evaporator coil access side. See forlocation.Condensate water can be drained directly onto the roof in rooftopinstallations (where permitted) or onto a gravel apron in ground levelinstallations. Install a field-supplied 2-in. (51 mm) condensate trap at theend of condensate connection to ensure proper drainage. Make sure thatthe outlet of the trap is at least 1 in. (25 mm) lower than the drain-pancondensate connection to prevent the pan from overflowing (See Fig. 7).Prime the trap with water. When using a gravel apron, make sure itslopes away from the unit.Connect a drain tube using a minimum of 3/4-in. PVC or 3/4-in. copperpipe (all field-supplied) at the outlet end of the 2-in. (51 mm) trap. Donot undersize the tube. Pitch the drain tube downward at a slope of atleast 1-in. (25 mm) for every 10 ft (3.1 m) of horizontal run. Be sure tocheck the drain tube for leaks.A09052Fig. 7 – Condensate TrapStep 7 – Install Flue HoodThe flue assembly is secured and shipped in the return air duct. Removeduct cover to locate the assembly (See Fig. 9).NOTE: Dedicated low NOx models MUST be installed in CaliforniaAir Quality Management Districts where a Low NOx rule exists.Table 1—Physical Data (Continued)UNIT SIZE 48090 48115 48130 60090 60115 60130NOMINAL CAPACITY (ton) 4 4 4 5 5 5SHIPPING WEIGHT lbSHIPPING WEIGHT kg491223491223491223496225496225496225COMPRESSOR / QUANTITY Scroll / 1REFRIGERANT (R-454B)Quantity lbQuantity (kg.)7.53.48.253.7MINIMUM CONDITIONED SPACE AREA (sq. ft.) 125 137REFRIGERANT METERING DEVICE Orifice TXVORIFICE ID in./mm .078 / 1.98 N/AOUTDOOR COILRows...Fins/in.Face Area (sq ft)1...2121.41...2121.41...2121.42...2117.52...2117.52...2117.5OUTDOOR FANNominal CFMDiameter in.Diameter (mm)Motor Hp (Rpm)350026660.41/5 (810)350026660.41/5 (810)350026660.41/5 (810)350026660.41/5 (810)350026660.41/5 (810)350026660.41/5 (810)INDOOR COILRows...Fins/in.Face Area (sq ft)3...175.63...175.63...175.63...175.63...175.63...175.6INDOOR BLOWERRequired Minimum Dissipation Airflow (CFM)Nominal Cooling Airflow (CFM)Size in.Size (mm)Motor HP (RPM)213160011x10279.4x2541.0 (1075)213160011x10279.4x2541.0 (1075)213160011x10279.4x2541.0 (1075)239175011x10279.4x2541.0 (1040)239175011x10279.4x2541.0 (1040)239175011x10279.4x2541.0 (1040)FURNACE SECTION *Burner Orifice No. (Qty...Drill Size)Natural Gas (Factory Installed)Propane Gas*. Based on altitude of 0 to 2000 ft (0-610 m).3...383...533...333...513...313...493...313...493...313...493...313...49HIGH-PRESSURE SWITCH(psig) Cut-out Reset (Auto)650 +/- 15420 +/- 25LOSS-OF CHARGE / LOW-PRESSURESWITCH (Liquid Line) (psig) cut-out Reset (auto) N/ARETURN-AIR FILTERS Throwaway† ‡in.mm†. Required filter sizes shown are based on the larger of the AHRI (Air Conditioning Heating and Refrigeration Institute) rated cooling airflow or the heating airflow velocity of 300to 350 ft/minute for throwaway type. Air filter pressure drop for non-standard filters must not exceed 0.08 IN. W.C.‡. If using accessory filter rack refer to the filter rack installation instructions for correct filter sizes and quantity.1 each 24x16x1610x406x2524x18x1610x457x25TRAPOUTLET1-in. (25 mm) min.2-in. (51 mm) min.