Carrier ROOM AIR CONDITIONER Installation Manual

Also see for ROOM AIR CONDITIONER: Operating manual User guide

Contents

11INSTALLATION INSTRUCTIONS(2) Install the panel(3) Hang the air-in grid to the panel, then connectthe lead terminator of the swing motor and thatof the control box with corresponding terminatorson the body respectively.(4) Relocate the air-in grid in the procedure ofreversed order, install the air-in grid.CAUTIONS:a. Align the swing motor on the panel to the waterreceiver of the body properly. (Refer to Fig.23)b. Hang the four fixed rope of the main body to theinstallation cover and the other three covers ofthe swing motor: (Refer to Fig.23 )c. Install the panel on the main body with bolt (M5×16)and washer. (Refer to Fig.23)d. Adjust the four panel hook screws to keep the panelhorizontal, and screw them up to the ceiling evenly.e. Regulate the panel in the direction of the arrow inFig.11 slightly to fit the panel's center to the centerof the ceiling's opening. Guarantee that hooks offour corners are fixed well.f. Keep fastening the screws under the panel hooks,until the thickness of the sponge between the bodyand the panel's outlet has been reduced to about4~6mm. The edge of the panel should contact withthe ceiling well. (Refer to Fig.24) Malfunctiondescribed in Fig.25 can be caused by inappropriatetightness the screw. If the gap between the paneland ceiling still exists after fastening the screws, theheight of the indoor unit should be modified again.You can modify the height of the indoor unit throughthe openings on the panel's four corners, if the lift ofthe indoor unit and the drainpipe is not influenced(refer to Fig.26-right).The installation cover of the swing motor must sinkinto the corresponding water receiver...CoverSteel ropeSwing motor installation coverDrain sideFig.23231BodyPanel foam2CeilingPanel foamAir plate Panel Panel foam1Panel sealing foamInlet airOutlet airFig.24Fig.26(3) The installation of ventilation motor andventilation pipe (if necessary)a. Using a tool to knock off the pre-punching hole.(Refer to Fig.27)b. Four screw hole reserved for installation.(Refer to Fig.27 )Fig.27Four screw holepre-punching holeSwing motor sideBolt, washerDrain sidePlease operate accordingto the direction of the arrow,or it can not be disassembledwhen it is necessary.43Hexagon nutCeilingHorizontal adjust mentCeiling LeakageDewFig.25