Carrier UC Open Installation And Startup Manual

Carrier UC Open Installation And Startup Manual Manual pdf 18 page image

Installing the UC OpenUC Open CARRIER CORPORATION ©2019Installation and Start-up Guide All rights reserved14LEDThe blue LED on the top of the Wireless Adapter indicates the following:If the LED is... Then the device...Off Is not powered or there is a problem.Blinking Is working properly.Steadily on Has a problem. Do one of the following:• Cycle power to the device.• Insert a small screwdriver or paper clip into the hole next to the LED to reboot thedevice.To wire an Equipment Touch to the UC OpenNOTES• The Equipment Touch requires a 24 Vac power supply. It is not powered by the Rnet.• If the Equipment Touch will be:○ Daisy-chained on the Rnet with ZS sensors or a Wireless Adapter, use the standard 4-conductor Rnetwiring and follow the wiring instructions To wire ZS sensors to the UC Open (page 11).○ The only device on the Rnet, you can use a 2-conductor cable instead of the standard 4-conductor Rnetcable and follow the instructions below.• For complete Equipment Touch installation instructions including wiring diagrams, see the Equipment TouchInstallation and Setup Guide.CAUTION The UC Open can share a power supply with the Carrier controller as long as:• The power supply is AC power.• You maintain the same polarity.• You use the power source only for Carrier controllers.1 Turn off the UC Open's power.2 Partially cut, then bend and pull off the outer jacket of the cable. Do not nick the inner insulation.3 Strip about 0.25 inch (0.6 cm) of the inner insulation from each wire.