Carrier UC Open Installation And Startup Manual

Carrier UC Open Installation And Startup Manual Manual pdf 20 page image

Installing the UC OpenUC Open CARRIER CORPORATION ©2019Installation and Start-up Guide All rights reserved16Wiring communication1 Turn off the UC Open's power.2 Wire the TruVu™ ET Display's RS485 connector to the 's Rnet port, Gnd to Gnd, + to Rnet +, - toRnet - using 2-conductor 22 AWG wire with a maximum distance of 500 feet (152 meters).3 Turn on the UC Open's power.For complete TruVu™ ET Display installation instructions, see the TruVu™ ET Display Installation and Start-upGuide.Installing the UC Open into the i-Vu® applicationYou must complete the following procedures to successfully install your UC Open into an i-Vu® Control System.Use the Help in the referenced software for detailed descriptions of these procedures.EquipmentBuilder or Snap1 Use EquipmentBuilder or Snap to create control program(s) for your UC Open.2 If applicable, print the Sequence of Operation, which includes the points list.NOTE You can create a points list under Reports in the i-Vu® application or Field Assistant after installingyour control program.This Installation Guide1 Prepare a wire list using the points list. Refer to Appendix A (page 23).2 Use the wire list and the following installation procedures to install and wire I/O points to your UC Open.The i-Vu® or Field Assistant application1 Upload the controller to the database by selecting the router in the navigation tree.2 Select Devices > Manage tab.