Carrier ZS Standard Installation Manual

Also see for ZS Plus: Application guide Installation guide User guide Installation guide

Carrier ZS Standard Installation Manual Manual pdf 19 page image

ZS zone sensorsZS Sensors Carrier Proprietary and Confidential CARRIER CORPORATION ©2017Installation Guide All rights reserved15Troubleshooting a ZS Pro or ZS Pro-FIf display shows... Then...Incorrect or missingvaluesCheck for errors in the i-Vu® application and Snap.On the control program's Properties page, select the Rnet Points tab. Verify thatvalues coming in from the sensors and those going out to the sensors are expectedvalues.In the i-Vu® application, double-click the Sensor Binder and ASVI microblocks tocheck for problems in the Status and/or Error columns.If the Error column shows Resource Allocation, try formatting the sensor. If the error isnot corrected by formatting, the control program engineer should reduce the numberof items that the sensor is trying to display.Nothing The sensor has no power.The sensor is not communicating with the network. Check:• Software/addressing setup• Wiring connections• Controller operating statusCharacters thatseem outof placeThe sensor may have a memory problem. Try formatting the sensor.Effective setpoints fields These fields display the effective setpoint values. They can display a maximum valueof 99 or 99.5 if the Edit Increment is set to 0.5. If the effective setpoint exceeds thismaximum value or if the Edit Increment is set to 0.1, the value will flash.TIP If you need an Edit Increment of 0.1, put the effective setpoints on theInformation screen in the Primary Value field. Hide the effective setpoints on theHome screen by selecting Sensor Setpoint Adjust Option 4 on the BACnet Setpointmicroblock's Rnet tab.