Casio MZ-X500 User Manual

Casio MZ-X500 User Manual Manual pdf 81 page image

EN-80Configuring Settings (Tutorial)This section explains general Digital Keyboard advanced settings. For information about other settings, see theDigital Keyboard’s USER’S GUIDE (Basics).1. On the MENU screen, touch “SYSTEM SETTING”.2. Use the “ ” button on the right side of the screen to display page 3/3.3. Touch “Advanced”.4. Advanced settings are described below.Configuring Digital Keyboard Advanced SettingsItem Description SettingOctave Button Target Use the ep OCTAVE w, q buttons to select the part whose octave you wantto change.Upper All, Upper 1,Upper 2, Lower All,Lower 1, Lower 2Sustain Button Target Use the eq SUSTAIN button to select the layer you want to change. Upper All, Upper 1,Upper 2, Lower All,Lower 1, Lower 2Sustain Button Upper1 Specifies how the sustain effect is applied to Upper 1 when the eq SUSTAINbutton is pressed.0 to 127Sustain Button Upper2 Specifies how the sustain effect is applied to Upper 2 when the eq SUSTAINbutton is pressed.0 to 127Sustain Button Lower1 Specifies how the sustain effect is applied to Lower 1 when the eq SUSTAINbutton is pressed.0 to 127Sustain Button Lower2 Specifies how the sustain effect is applied to Lower 2 when the eq SUSTAINbutton is pressed.0 to 127N. Gate Thresh Specifies the noise gate threshold value. Cuts low-volume input sounds, whichdecreases noise. Allows a signal input from the LINE IN terminal to passthrough if it is above the set threshold (gate open). Does not allow a signal topass if it is below the threshold (gate closed).0 to 127Init By Wave(MZ-X500 only)Parameter initialization by wave selection. Select “On” to link the envelope andother parameters when a wave is selected or select “Off” not to link.Off, OnExp. Pedal Calibration Performs an expression pedal calibration operation. Before performing thisoperation, select “Exp. Pedal” (expression pedal) for the “Pedal 2 Type” settingon the CONTROLLER screen.1. When the message “Move the expression pedal to the highest position andPress “OK”” appears, keep the pedal depressed as your touch “OK”.2. When the message “Move the expression pedal to the lowest position andPress “OK”” appears, keep the pedal released (pedal open) as you touch“OK”. The message “Complete!” will appear on the display when theoperation is complete.• Touch bo EXIT to exit the calibration operation.Menu Setting Changes the arrangement of the icons on the MENU screen. On the MenuSetting screen, use the “e” and “r” buttons to move each item upwards ordownwards. This will change the order of the icons on the MENU screen.