SE-S100 / PCR-T285 / PCR-T295– 3 –3. INITIALIZATIONImportant:Main PCB (E261-1 PCB) supplied as spare parts have been pre-installed application and diagnosticsoftware without LOCALE code.Then LOCALE code should be set at first when you replace a main PCB from spare parts in your stock.Initial LOCALE judgment/settingsDoes LOCALE information exist ?YesNoYes Does LOCALE information exist ?NoDoes Flash ROM information exist ?YesNoSet the Mode switch to the position other than [OFF].Set LOCALE code.Command: d1 d2 0016oUnplug from AC outlet.Wait 10 sec., then plug into AC outlet.( Restore INIT )EndAfter IPL is completed.Go to the setting procedure by destination.1020305060EUUSUKCANADAOther areasd1 d2: LOCALE codeDiagnostic program modeRemove the memory protection batteries from battery compartment and unplug the power cordfrom AC outlet.After 10sec. or more, set the memory protection batteries into battery compartment and plug thepower cord into AC outlet.Tips: Regarding to deletion of the LOCALE informationIn diagnostic program mode, input the following command.2 1 6 o