Quick Start Guide1. To set memory protection bat-teriesTo prevent losing all your settings and sales data, westrongly recommend that you set the memory protectionbatteries before you use the cash register and replacethem at least once a year.1. Remove the printer cover by lifting it up.2. Remove the battery compartment cover.3. Note the (+) and (–) markings in the battery compart-ment. Load a set of two new “AA” type manganesebatteries so that their plus (+) and minus (–) ends arefacing as indicated by the markings.4. Replace the battery compartment cover and theprinter cover.ImportantThese batteries protect information stored in yourcash register’s memory when there is a powerfailure or when you unplug the cash register. Besure to install these batteries first.WarningNo battery is included in the accessories.Never try to recharge the batteries.Do not expose batteries to direct heat, let thembecome shorted or try to take them apart.Keep batteries out of the reach of small children.If your child should swallow a battery, consult aphysician immediately.There is a risk of explosion if the batteries arereplaced with improper type.2. To set receipt paper1. Open the platen arm by lifting it up.2. Ensuring the paper is being fed from the bottom of theroll, lower the roll into the space behind the printer.3. Put the leading end of the paper over the printer.4. Close the platen arm slowly until it locks securely.WarningNever touch the printer’s thermal head and theplaten. Avoid the thermal paper from heat, humidityor direct sunlight.platen arm5. Replace the printer cover, passing the leading end ofthe paper through the cutter slot. Tear off the excesspaper.3. To install journal paper1. By the same procedure of setting receipt paper, setjournal paper on the journal printer.2. Using j key, feed the paper about 20 cm.Remove the paper guide of the take-up reel.3. Slide the leading end of the paper into the groove onthe spindle of the take-up reel and wind it onto thereel two or three turns.4. Replace the paper guide of the take-up reel.5. Place the take-up reel into place behind the printer,above the roll paper.6. Press the j key to take up any slack in the paper.7. Replace the printer cover.4. To turn the cash register on1. Insert a Mode key that comes with the cash register inthe Mode switch and turn it to OFF position.PGM2. Plug in the power cord into an AC outlet.PreparationsNote: Please follow the steps described below.Electronic Cash Register SE-S3000/SE-C3500Q SG294*E