Caslon Maxit 305 Operation And Maintenance Manual
Also see for Maxit 305: Operation and maintenance manual
            | |
Page 92. Adjust the operating temperature:MX Adhesive - If the knob is at the 12 o’clock position; turn it to 11 o’clock and if at the1 o’clock position turn to 12 o’clock. Allow approximately 30 minutes for the machineto achieve the correct new temperature.RP Adhesive - If the knob is at the 11 o’clock position; turn it to 12 o’clock and if at the12 o’clock position turn to 1 o’clock. Allow approximately 30 minutes for the machineto achieve the correct new temperature.3. Also it is important to keep the entire coating roller hot. Consequently, when you firststart using it in the morning or if you have not used it for a while during the day, turnon the motor for 30 seconds before you use it to get the roller hotter.4. If you are using it to coat multiple prints, then leave the motor running and you will findany stringiness should be reduced or eliminated. Also make sure you keep the adhesivelevel up to keep the roller hot. The adhesive should not come off on your fingers andwill not at the correct temperature.Trouble Shooting GuideStart UpIssue: The ready light will not come on after 55 minutes, so the motor will not run even thoughthe adhesive is melted.Cause: This is very rare, but can happen the first time you use Maxit due to a thermostat in themachine being impacted during shipping.Solution: A slight adjustment is needed on the motor thermostat. Contact your local dealer andthey will email you the instructions. Once you make the correct adjustment, you should notneed to do it again.Issue: The adhesive is melting, but not getting hot enough.Cause: Not enough power coming into the Maxit due to too many items plugged into the sameoutlet or using a poor grade extension cord. Also, make sure the temperature knob has notbeen moved to the left, lower than the 11:00 position.Solution: Remove other items from outlet. Also see if you can plug directly into outlet insteadof using the extension cord. If you must use a cord, it needs to be heavy gauge.Issue: Smoke coming out of adhesive in tray or very strong odour.Cause: The Maxit is running too hot. It is not unusual for the Maxit to run hotter in yourpremises than in our quality control room due to voltage variations. Also, running the motor forlong periods of time will heat up the adhesive significantly.Solution: turn the temperature knob slightly to the left. If you are at the 1:00 position, turn it to12:00. If at 12:00, turn to 11:00. The Maxit takes around 30 minutes to reset the overalltemperature. |
Related manuals for Caslon Maxit 305
manualsdatabase
Your AI-powered manual search engine