Page 5Start UpImportant: During warm up, the coating roller gets heated up by the adhesive. It is veryimportant that the level of the adhesive be above the “full” block (top block, located in theleft side of the tray). If the adhesive is too low, the warm up will take longer and the rollerwill have trouble turning.Connect the machine to an approved outlet and switch the machine on by using the red‘Power’ button mounted on the rear of the machine.Warm up time is normally 55 minutes. When the machine has reached the correct operatingtemperature the ‘ready’ light on the front of the machine will illuminate. The motor can nowbe switched on allowing the coating roller to turn. When switching on the motor, alwaysallow the roller to turn for 20 seconds to help it reach the correct operating temperature.Adhesive TypeMXII AdhesiveFormulated for book covers and any application where a tight fold back and extra strongadhesion is required. This adhesive never dries out so can be used at any time after coating andsticks to almost any surface. Not suitable for products that require guillotining after gluing.The MXII adhesive runs better at a lower temperature and a usual setting for this is with theknob at the 12:00 o’clock position.RP AdhesiveFormulated for any requirement where flat surfaces are to be glued together. Provides a stifferbond on flexible products and allows some re-positioning, especially if left open for a shorttime. Will cure out over time and greatly reduces sticking to your guillotine blade.This adhesive generally runs better at a higher temperature with the knob set around the 1:00o’clock position.Applying adhesiveThe Maxit adhesive is very strong, so for most lightweight stocks or photographic papersyou only need a very thin coating. For textured or thicker stocks, such as canvas, you wouldneed a heavier coating.Feed and catch leading edge Guide longer prints towards front