Cavius 2203-002 User Manual
Also see for 2203-002: User manual
All alarms to be connected in the house should be putinto ‘Learn Mode’ by sliding the switch on the back ofthe alarm to the ‘Learn Mode’ position.As the other alarms receive the specific house code,they will also flash the LED light.When all alarms flash the red LED, they are connectedand can be switched out of ‘Learn Mode’ and installed.The distance between interlinked alarms depends onthe house layout and they should always be tested afterinstallation. It is not advised to install alarms with aseparation of more than 10m.Diameter: 97mm. Height: 41mm (without mountingbase) 52mm (with mounting base).Interlinked by RF: 926.365 MHzComplies to standards: AS3786:2014Mains powered smoke alarm deviceModel number: 2203-002Developed by CAVIUS™This smoke alarm is designed for private homes.TECHNICAL INFORMATIONThe smoke alarm is powered by mains power (110-230V AC), with a lithium CR2 back-up battery.It can be Radio Frequency (RF) interlinked with other2203 alarms and with other CAVIUS™ Wireless Familyalarms. The maximum number of alarms that can beinterlinked within a house group are 32.Please note: These must be alarms from the CAVIUS™Wireless Family range.CHAMBERFILTEROPTIONAL HOLEFOR LAMP WIRETEST BUTTONSIREN RED & GREEN LED1. HOW TO SET UP AND CONNECT ALARMS:Start by pulling out the battery isolation strip in thebattery compartment as shown.Please note: RF connection is done with the devicepowered with battery only. You do not have to connectthe power supply unit. The product label must not beremoved as it contains important information regardingthe product.MAINSPOWEREDSMOKE ALARMISOLATIONSTRIP1 NORMAL MODE2 LEARN MODE12PLEASE READ THE USER GUIDECAREFULLY BEFORE INSTALLATION ANDRETAIN FOR FUTURE USE.Please note: The learn switch placed on the back ofthe alarm can only be in learn position when the alarmis disassembled from the power supply unit. The learnswitch will automatically switch to normal positionwhen the alarm head is fitted to the power supply unit.The red LED will light up to indicate that ‘Learn Mode’has been selected.Do not remove the battery during ‘Learn Mode’ asthis will interrupt the learn process. Press and hold thetest button on one alarm only, until it beeps and theLED flashes. This alarm will become the master and willstart sending out a specific house code to theother alarms.2. THE BEST AREAS TO INSTALL THE SMOKE ALARM:• Note the local country regulations regarding installationand compliance.• Note the local regulations and information for insurancecompany policy regarding installed smoke alarms.• Install an alarm between possible fire sources andbedrooms as a minimum.• Install alarms on each floor of the house, in hallways andstairways.• Alarms in each room such as bedrooms and living rooms.Additional alarms increase the security.3. AREAS WHERE NOT TO INSTALL SMOKE ALARMS:• In dusty rooms• At the top of a high pointed ceiling, in ceiling corners,and within 50cm of a wall.• In rooms where temperature goes outside the range+4° to 38°C or above 90% relative humidity notcondensing.• In kitchens, garages, laundries, or too close tofireplaces; areas where either dampness, gases orsmoke could occur.Place the alarm where it is reachable in order to test thealarm and for maintenance.Smoke HeatMinimum 50cm from wallWallCeilingMinimum 50cmfrom peak.Ceiling1 |
Related manuals for Cavius 2203-002
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine