15Programming the quantity of coffee and milkin the cup for the CAPPUCCINO, FLAT WHITE andLATTE buttonsThe appliance is set by default to automatically deliver standardquantities. To change these quantities, proceed as follows:1. Place a cup under the coffee spouts and milk spout.2. Select the desired froth dial position for the drink type tobe programmed.3. Press and hold one of the function buttons until the nameof the hot drink and the message “PROGRAM MILK” isdisplayed.4. Release the button. The appliance starts delivering milk.5. Once the required quantity of milk has been delivered intothe cup, press the button again.6. The appliance stops delivering milk and, if included in thedrink, after a few seconds the coffee is delivered into thecup: the name of the hot drink and “PROGRAM COFFEE” isdisplayed.7. Once the required quantity of coffee has been deliveredinto the cup, press the button again. Coffee delivery stops.The machine is now reprogrammed with the new milk and cof-fee quantities.Programming the quantity of coffee and milk inthe cup for the MILK MENU button drinksThe appliance is set by default to automatically deliver standardquantities.To change these quantities, proceed as follows:1. Press the MILK MENU button.2. Press < or > until the required drink is displayed (MILK,CAFFELATTE, ESPRESSO MACCHIATO or MY MILK).3. Hold the OK button until the name of the drink and “PRO-GRAM MILK” are displayed.4. Release the button. The appliance starts delivering milk.5. Once the required quantity of milk has been delivered intothe cup, press the OK button.6. The appliance stops delivering milk and, if included in thedrink, after a few seconds the coffee is delivered into thecup: the name of the hot drink and “PROGRAM COFFEE” isdisplayed.7. Once the required quantity of coffee has been deliveredinto the cup, press the OK button again. Coffee deliverystops.The machine is now reprogrammed with the new milk and cof-fee quantities.DELIVERING HOT WATER AND STEAMImportant! Danger of burns.Never leave the machine unsupervised while delivering hotwater or steam.The spout becomes hot. Hold by the handle only.Please note!If “Energy saving” mode is active, you may have to wait a fewseconds before the hot water or steam is delivered.Delivering hot water1. Make sure the hot water spout is attached correctly (fig. 7).2. Place a container under the spout (as close as possible toavoid splashes).3. Press the button (fig. 3). “HOT WATER” is displayed,together with a progress bar which fills gradually as pre-paration proceeds.4. The machine delivers 250 ml of hot water, then deliverystops automatically. To interrupt delivery of hot water ma-nually, press the button again.Changing the quantity of water deliveredautomaticallyThe machine is set by default to automatically deliver 250 mlof hot water.To modify these quantities, proceed as follows:1. Position a container under the spout.2. Press and hold the button until “Hot water Programquantity” is displayed, then release the button.3. When the hot water in the cup reaches the required level,press the button again.The machine is now reprogrammed with the new quantity.Delivering steam1. Make sure the hot water spout is attached correctly (fig. 7).2. Fill a container with the liquid to be heated/frothed andimmerse the spout/traditional frother (D5) in the liquid.3. Press the button: after a few seconds, steam comesout of the traditional frother and heats the liquid; “STEAM”is displayed.4. When the required temperature is obtained, interruptsteam delivery by pressing the button. (You should notdischarge steam for more than 3 minutes at a time).Important!Always stop steam delivery before extracting the container con-taining the liquid to avoid burns from splashes.