[Cleaning Battery Terminals]˝ Turn the seat lock switch to the rightusing the main switch key.˞ Loosen the washer screw and removethe battery cover.˟ Loosen the tapping screw and removethe battery holder.ˠ If the battery terminal is polluted, or inrust, separate battery and clean it.ˡ Battery terminal in rust with whitepowder should be cleaned with warmwater.ˢ In case of serious rust of battery ter-minal, disassemble the battery cordand grind it with wirebrush orsandpaper.[Replenishing Battery Water]This vehicle doesn’t need either reple-nishing or checking battery water becauseof the equipment of enclosed MF battery.In case battery needs a checking, it shouldbe cared of by service center.42Battery InspectionCautionBe careful not to disassemble in-jection part of enclosed battery.When not using vehicle during along time, take off the battery fromthe vehicle to keep from self-discharge and electric discharge.Put the battery in a well ventilatedplace after charging fully. In case itisn’t available to take battery offfrom the vehicle, disconnect “-”terminal.#"55&3:CautionTurn the ignition switch OFFbefore disconnecting the terminalfrom the battery.When cleaning battery, do notdisassemble the battery cap toprevent foreign materials fromfalling inside battery.Remove the negative pole 䥴 sidecord first and the positive pole 䥳side cord next.Make sure, at this time, that 䥳side cord is connected first,followed by 䥴 side cord.