17Manual del Usuario / action 500 series / User’s Manual1 2 live off0.0mO+ 2 dB1C2 live off0.0mOINPUTCLIP1L2 live off0.0mOLIMITMAIN MENUBACKPRESET: LiveHPF: Off1 2 live off0.0mO0 dBlive presetMAIN MENUBACKPRESET: LiveHPF: OffMAIN MENUBACKHPF: OffPRESET: Live >MAIN MENUBACKHPF: OffPRESET: MAIN MENUBACKHPF: OffPRESET:Differences between PresetsDISPLAY (except ACTION-S18A, ACTION-S118A & ACTION-S218A)1 2 live off0.0mO0 dBADJUSTING THE LEVELS:By default the state of the screen is thefollowing:Once the input source (s) have beenconnected to the amplifier´s cabinet, the user hasto adjust the levels.For the two input channels (1 and 2), twoindependent gain controls are available. Becareful when setting the input volume and do notexceed the maximum level shown on the meters:(input clip shown on channel one)peakmeters RMSmeterExceeding the limitsmay causespeaker failure!!Exceeding the limitsmay causespeaker failure!!After having set the input volume valuesunder the maximum level, user has to adjustouput volume with the master control. The levelis shown in the right meter of the screen. As withthe inputs be careful not exceeding the limit:(LIMIT shown)After these two volume adjustments thescreen will show something like this (whenhaving the input sources ON):It is highly recommendableworking with output volumebelow 0dB. If maximum levelis required user shouldincrease the output level(higher than 0dB)MAIN MENU:As stated previously by pushing the encoderthe user can access to the following options inthe MENU:Note: to enter and select and option always push the encoder. For going back in the menu, the userhas to select Back on the screen and press the encoder or just pushing the encoder.After 30 seconds without using the unit it will go back to the main screen automatically.PRESETS:Three factory settings (live, dance, monitor)depending on the type of music/use that hasbeen configured inside the unit:With the encoder go to Preset Sub-menu andpress the knob to access to the different options:Notes:The only models in this series that do nothave a display are: ACTION-S118A and ACTION-S218A.In the model ACTION-M512A the presetactivated by default is "Monitor" while in theother models it is "Live". While your preset is"Monitor" the display will turn off completelyduring use.If in the "LOGO" menu we have chosen the"Limit" option, the anagram will flash when thelimiter is activated. If we have chosen "On" it willremain lit, while if the option chosen is "Off" itwill remain off.10k5k2k1k500200100502020 20kdBSPL10k5k2k1k500200100502020 20kdBSPL10k5k2k1k500200100502020 20kdBSPLLiveDanceMonitor
