DCS BGC Series Installation Instructions And User Manual
Also see for BGC series: Installation instructions and user guide
                                            | |
18TROUBLESHOOTINGBurner won’t light when theignition is pushed.Burner flame is yellow or or-ange, in conjunction with theodor of gas.Low heat with knob in “HI”position.Remove the burner grate. With the control knob in the“OFF” position, push the control knob in and listen to theelectrode. There should be a spark from the electrode.When the spark jumps, it makes a ticking sound.If there is no spark........Could be a dead battery. Try replacing the battery.Or the air gap between an electrode tip and a contactmetal is too far (gap should be 1/8”) or dirty.If there is a spark... is there gas supplied to the unit andis the line purged of air? See Fig. 06 and Fig. 07.Does the other burner of a dual burner modeloperate?Check the orifice or venturi for blockage.Check the burner for obstructions or dirt. See page 14.Check for proper gas supply or wrong gas type.Is the side burner in a dusty area? Move to less dustyarea if possible.Is the fuel hose bent or kinked? See Fig. 06 andFig. 07.Is there adequate gas supply available? If it is only oneburner of the dual burner unit that appears low, doesthe burner need cleaning? See Fig. 12 andFig. 13.If using LP gas, check for empty tank or low fill level.PROBLEM WHAT TO DO |
Related manuals for DCS BGC series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine