DCS BGC Series Installation Instructions And User Manual
Also see for BGC series: Installation instructions and user guide
                                            | |
7INSTALLATIONINSTALLATION OF SIDE BURNER ON BGB30-CSS CARTSTEP 31. Bolt the side burner to the grill cart side panel from the under side of the burner assembly with a shoulder boltin the front and 1/4 x 20 bolt in the back as shown. Do not forget to use 1/4 flat washers. Do not tighten. Adjustthe side burner until it is level to the grill; then tighten securely.2. Bolt the support brackets to the bottom of the side burner with (4) #10-24 machine screws, nuts and washersprovided.3. Replace the drip pan, grate and cover.Note:Once the side burner is assembled, refer to the “Gas Requirements” section for proper gas hook-up requirements.SIDE BURNERBOLT (1/4 – 20)Shoulder Bolt1/4-20 x 5/16SCREW #10 (4 PCS)WASHER #10 (4 PCS)WASHER FLAT1/4 X .938 (2PCS)NUT#10 (4 PCS)FIG. 02 |
Related manuals for DCS BGC series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine