DCS CTD-304 Installation Manual

Also see for CTD-304: Specifications Use and care manual Use and care manual

Contents

DCS CTD-304 Installation Manual Manual pdf 13 page image

11INSTALLER FINAL CHECKLISTGENERALo Placement of Unit.o Specified clearance maintained to cabinet surfaces.o Unit Level- front to back, side to side.o All packaging material and tie straps removed.ELECTRICAL:o Receptacle with 15 ampere circuit protection is provided for service cord connection.o Adequate ground connection.GAS SUPPLY:o Connection: 1/2 NPT with a minimum 5/8” diameter flex line.o The pressure regulator which is connected to the manifold is set for 4.0” W.C. for Natural Gas or 10” W.C.for LP.o Manual gas shut-off valve installed in an accessible location.o Unit tested and free of gas leaks.OPERATION:o All internal packing materials are removed, i.e. below grates, around knobs, etc.o Bezels centered on burner knobs and knobs turn freely.o Each burner lights satisfactorily, both individually and with other burners operating.o Low flame operation verified.o All burner caps, burner rings and burner bases correctly seated in position, level, and do not rock orslide.o Burner grates correctly positioned, level, and do not rock.