DDDrop EVO TWIN Installation And User Manual
                     | |
15EN 190524WARNINGFailure to remove ALL material of a previous build from the heated bed or a badly adjusted heatedbed can cause a collision and damage machine components.5.2 Preparing heated bed1. Clean the heated bed from residue of other prints.2. Empty the container (see 6.2) and clean the brush (see 6.3).3. Clean the heated bed.4. Level the bed with the ‘Bed levelling tool’ in the Tool tab.5. Turn the printer ON by switching the switch on the back of the printer to the ‘I’ position andwait for the printer to be initialized.WARNINGThe machine contains hot and moving parts. It is strongly advised to only print with cover closed.The machine can be stopped AT ANY TIME in case of an emergency by switching the power OFF ordisconnecting the power cord.5.3 Start Print1. Check if the container is empty and the brush and heated bed have been cleaned.2. Check if the cover is correctly closed.3. Select in the ‘File tab’ the Gcode you want to print and confirm this code by pressing on thecheckmark. The printer will be started automatically. In the Status tab the process of theprint can be followed.5.4 Taking out the printed model1. Before opening the cover: Check if the printer is ready. The status bar should display printfinished and the total print time is given. The extruder is in its XY home position and the settemperatures are in cooldown mode.2. Before opening the cover: Check if the printer is cooled down. The actual temperatures ofthe nozzles and heated bed are given in the ‘Status tab’.3. Open the cover with both hands and check that the hinge is in lock position.4. Take out the printed model. When it seems to be stuck, the heated bed is probably still toohot to take out the product. Allow the bed to cool; the product will automatically becomefree. Be careful when using spatula or other tools to remove the product. Use protectiveclothing (e.g. gloves, safety glasses etc.)!5. Empty the container and clean the bed so it’s ready for the next print.6. Turn OFF the printer by switching the power switch to the O position. |
Related manuals for DDDrop EVO TWIN
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine