Machine descriptionOperating Instructions 610-10/630-10 - 01.0 - 01/2021 153 Machine description3.1 Overview of machine componentsFig. 1: Overview of machine components(1) - Tape unwinder(2) - Machine head(3) - Stand(4) - Pedal(5) - Knee button(6) - Controller(7) - Control panel(8) - Thread reel holder③④⑧⑤①⑥④② ⑦

DURKOPP ADLER 610-10 Operating Instructions Manual

About these instructions

Safety

Signal words and symbols used in warnings

Working basis

Tilting and re-erecting the machine head

Disassembling and assembling the oil pan

Disassembling and assembling the head cover

Disassembling and assembling the arm cover

Disassembling and assembling the upper belt guard

Disassembling and assembling the lower belt guard

Disassembling and assembling the throat plate

Removing disruptive components

Disassembling and assembling the needle guard

Disassembling and assembling the looper and looper mounting

Disassembling and assembling top feed foot and sewing foot

Disassembling and assembling the feed dogs

Flats on shafts

Setting the locking positions

Individual settings

Set of gages and wrenches

Positioning the needle

Setting the lower toothed belt wheel

Setting the sewing foot

Setting the speed of the sewing foot lift

Setting the looper

Draining and filling the oil in the looper drive housing

Removing and placing the looper drive housing

Setting the left lower shaft bearing

Setting the rocker bolt

Setting the looper drive housing

Setting the needle evasive movement (ellipsis width)

Setting the needle evasive movement

Swiveling down the needle guard

Setting the looper in the looper mounting

Setting looper and needle bar

Setting loop stroke position and looper clearance

Setting the needle bar height

Setting the retention spring on the looper

Adjusting the needle thread quantity

Setting the looper thread quantity

Setting the needle guard

Differential top and bottom feed

Setting the thrust movement of the feed dogs

Setting the height of the feed dogs

Performing the basic setting of the bottom feed linkages

Top feed foot

Setting the stroke height of the top feed

Setting the stroke movement timing

Setting the thrust movement timing

Setting the position of the top feed foot

Performing the basic setting of the top feed linkage

Setting the thread take-up disk

Setting the thread cutter

Adjusting the thread guide on the machine arm

Setting the tape feed (610-10 only)

Setting the reinforcement tape feed into the tulle foot

Setting the tape feeding speed

Setting the tape cutter position

Programming

Menu items at the Technician level

Menu item Default Program Parameters

Menu item Machine Configuration

Thread Trimmer

Stop Positions

Other Devices

Menu item USB Operations

Menu item Calibration

Motor Calibration

Thread Tension Calibration

Menu item Reset Operations

Reset All

Maintenance

Cleaning

Lubricating

Lubrication of the machine head

Looper lubrication

Servicing the pneumatic system

Draining the water condensation

Cleaning the filter element

Checking the toothed belt

Decommissioning

Disposal

Troubleshooting

Technical data

Appendix

610-10

630-10