DURKOPP ADLER 867 - 10-2010 Instruction Manual

DURKOPP ADLER 867 - 10-2010 Instruction Manual Manual pdf 13 page image

3.3 Assembling the stand components (Long arm)– Assemble the individual stand components as shown in theillustration.– Adjust the set screws 8 to insure the stability of the stand.Make sure that the stand is safe by insuring that every single footof the stand touches the ground.3.4 Assembling the table plate(867-190040-70, 867-190342-70*, 867-290040-70, 867-392242-70*)In order to have an optimal arrangement of the components,please follow the layout.Stand LayoutMG58 400414 0791 867716MG58 400404 0791 867715– Screw the drawer 10 with its holders onto the left side underneaththe table plate.– Screw the oil sump 7 under the table plate.– Put the cap 5 into the bore hole of the table plate.– Screw the cable duct 4 # under the table plate.– Place the hinge bottoms 12 for the machine head into the cutoutof the table plate and tighten the screws.– Insert the rubber corner 2.– Attach the table plate 11 to the stand with woodscrews (seesketch for position).– Insert the reel stand 1 in the hole in the table plate and secure itwith the nuts and washers.Fit and align the yarn-reel and unwinding holders.The yarn-reel holder and the unwinding arm must be vertically inline.– Screw the holder for the oil-can 9 onto the left-hand stand brace.* MG58 400414 only available for the above-quoted underclass.# Not applicable with sewing machines with direct drive.3.5 Self-manufacture of the table topIf you manufacture the table top yourself, please take themeasurements from the illustrations on pages 43 and 44.9GB