DURKOPP ADLER 911-211-10 Operating Instructions Manual

Programming50 Operating Instructions 911-211-10 - 00.0 - 10/20205.8 Continuing a seam after an error5.8.1 Continuing a seam in Repair mode after an errorIn Repair mode you can move to any desired point on the contour, e.g. inorder to continue the seam program from this position after an error hasoccurred.To continue a seam in Repair mode after an error:1. Press the button Repair mode on the start screen. The Repair mode window is displayed.Fig. 35: Continuing a seam in Repair mode after an error2. Use the Forwards and Back buttons to move to the point where sewingis to continue.OR3. Use the buttons Forwards ++ and Back ++ to skip to the beginning ofthe next or the beginning of the previous seam section.4. Press the Continue sewing button. The program jumps back to the start screen and sewing of the seamcontinues from the selected point.