FRONT AXLES ELEMENTS3131 - 15Steering knuckle bearing (35 x 65 x 35)DISMOUNTINGDismount the steering knuckle (see method“Dismountingsteering knuckle).Remove the safety ring ( bore ring) from theinterior of the steering knuckle.Depress the biconical bearing, using a→ 50 mm outer diameter rod.Place the steering rod using a bushing withinner diameter→ 67 mm.REMOUNTINGIntroduce in the steering knuckle the bearingsupport washerPress the bearing in the steering knuckle, bymeansof a → 63 mm diameterbushing.Mount the safety ring in the channel of thesteering knuckle bore.REMARK:The operation shall be performed so thatbushing is not pressed on the bearingsupport washer,in order to perform a correctmounting and not to damage the bearing.The steering knuckle-bearing assemblyisto be placedabove thehub and aftercenteringthe support washer, press the bearing on thehub, using a bushing with the inner diameterof Ø36 mm and an exterior diameter of Ø40 mm.Continue withthemounting of the steeringknuckle assembly on the vehicle (see themethod “Remounting steering knuckle”)REMARK :When replacing the bearing, its spaceris also to be obligatory replaced.ΦΦΦΦ 50ΦΦΦΦ 67ΦΦΦΦ 64Φ 40AΦΦΦΦ 40ΦΦΦΦ 36vnx.su
