1510. Reinstall the drain outlet cover.11. Center the fine particle filter over the hole in thebottom of the dishwasher.12. Re-attach the strainer basket to the tubular filter.13. Insert the tubular filter assembly into the holewith the handle pointing toward the front of thedishwasher. Turn the handle once clockwise untilit stops to secure it in place.14. Replace the bottom rack.15. Reconnect power to the dishwasher.1xCleaning the Spray ArmsThe holes and bearings on the spray arms cansometimes become blocked. Clean them as followsto restore proper operation.1. Open the door and remove the bottom rack.2. Pull the bottom spray arm straight up to release.3. Remove any deposits using a needle orsomething similar. The washer arms also haveholes underneath.4. To reinstall, center the base of the spray arm inthe hole and push straight down until it clicks intoplace.5. Replace the bottom rack.6. To release the top spray arm, first remove thetop rack. Pull the top rack out until it stops. Turnboth rack stops outwards on the rack mountingrails (see diagram). Pull the rack toward you toremove it.7. Remove the top spray arm in the same way asthe bottom arm and clean it. Reinstall the topspray arm the same way as the bottom one.8. Reinstall the top rack by inserting the rollers onthe base of the rack into the slots on the rackmounting rails. Turn both rack stops inward tolock the rack into place.Care and CleaningRack stop