8Operating Your Wine Dispensing SystemTurning the System ON/OFF1. Open the door on the front of the unit. Swing thespout cover to the up position.2. To turn the unit on, slide the power switch allthe way up to the ON position. When poweringon, the unit will run through a series of diagnos-tics, which will take several seconds.NOTE: If the control panel is LOCKED see page15 to unlock. The control panel may lock whenthe system is turned OFF or after a power fail-ure. The lock may also be turned on intentionallyfrom the control panel. See page 15.3. To turn the unit off, slide the power switch allthe way down to the OFF position.4. Lower the spout cover by pushing up and hold-ing the lever on the bottom as you lower itdown. CAUTION: Do not push down on thespout cover without pushing up on the lever.Damage to the lever will result.5. Once the spout cover is closed, close the bottlebay door. push in slightly just above the lockuntil it snaps shut.RegulatoradjustmentknobGas supplyline from winedispensingsystemRegulatorassemblyArgongascylinderSpout coverrelease lever(on bottom ofspout cover)9. Find the gas regulator assembly that comes withthe unit.WARNINGTo avoid personal injury, use only the included gaspressure regulator or a Dacor specified replacement.11. Make sure the regulator adjustment knob isturned all the way in the OFF direction.12. Connect the gas supply line from the winedispensing system to the gas connector on theregulator assembly.13. Remove the plastic cap from the top of theargon gas cylinder (must be ordered separately,see page 23).14. Insert the top of the gas cylinder into thebottom of the gas regulator assembly and turn itclockwise, by hand, until it is snug. Do not use awrench or overtighten.15. Turn the regulator knob in the ON direction untilit stops.16. plug the power cord into the grounded 120 Vac.,60 Hz. electrical outlet.Setting Up Your Wine Dispensing SystemPreparing to Use Your Wine Dispenser for the First Time (cont.)ONOFF