Dacor ECS127SBK Installation Instructions Manual

Contents

Dacor ECS127SBK Installation Instructions Manual Manual pdf 4 page image

3DacorModelNumberOverallWidth“E”OverallHeight“F”ChassisDepth“G”RecessWidth“H”RecessHeight“J”RecessDepth“K”ECS127 27”(686mm)28 3/8”(721mm)23 7/8”5”(127mm)5 1/4”(133mm)8”(203mm)MCS127ECS13030”(762mm)6 1/4”(159mm)PCS130MCS130ECS136 36”(914mm)28 5/8”(727mm)6 3/8”(162mm)MCS22727”(686mm)49 15/16”(1270mm)5”(127mm)MCS227ECD227MCD227ECS23030”(762mm)6 1/4”(159mm)PCS230MCS230ECD230PCD230MCD230Overall Dimensions"E""F"1"(25mm)"G""K" Recess1 5/16"(33mm)"H"48 5/8"(1235mm)"J"Rotatingelbow60" (1524mm)Flexible conduit3/8"(10mm)"G""F"1"(25mm)"K"1 5/16"(33mm)"H""E""J"60" (1524mm)Flexible conduitRotatingelbow3/8"(10mm)CooktopRegulatorRecess3 5/8"(92mm) 1"(25mm)EPICURE™1"(25mm)MILLENNIA™2 3/8"(60mm)PREFERENCE™ Double Wall OvenOverall Dimensions(Epicure Shown)Single Wall OvenOverall Dimensions(Epicure Shown)Side View -Handle ProjectionsInstalling the Support Platform inthe CabinetProvide a platform within the cabinet upon whichthe oven will be supported. The platform mustbe installed level and straight. The top edge ofthe platform must be flush with the cutout at thefront of the cabinet. There are no provisions tolevel the oven after it has been installed. 3/4”(19mm) thick plywood is recommended.NOTE:An oven that is not level mayprovide poor or inconsistentbaking results.Electrical Power SupplyRequirementsIt is the owner’s responsibility to ensure thata qualified electrician performs the electricalconnection of this appliance. The electricalinstallation, including minimum supply wire size,must comply with the National Electric CodeANSI/NFPA 70-1990* (or to the latest revision)and local codes and ordinances.*A copy of this standard may be obtained from:National Fire Protection Association1 Batterymarch ParkQuincy, Massachusetts 02269-9101The correct voltage, frequency, and amperagemust be supplied to the appliance from aseparate, grounded, single phase circuit that isprotected by a properly sized circuit breaker ortime-delay fuse. If a time-delay fuse is utilized,fuse both sides of the line (L1 and L2).The required voltage, frequency and amperageratings are listed on the product data plate(located inside the intake grill to the right of thedoor latch) and in the Table on page 4.WARNING:If the electrical service provideddoes not meet the productspecifications, do not proceedwith the installation. Call alicensed electrician to correct.NOTES:1. Preheat times and cavitytemperature recovery timeswill be increased slightly ifoperating on a 120/208 voltpower supply.2. 208V models should not beconnected to 240V sourcepower.3. Power supply must be anisolated circuit.