Dacor ED30 Installation Instructions Manual

Also see for Epicure ED30: Use and care manual Planning guide Installation instructions Use and care manual Installation instructions

Contents

Dacor ED30 Installation Instructions Manual Manual pdf 11 page image

Cabinet Panel Installation(Model ID30 Only)CAUTION• To prevent corrosion and the possibility of the panelfalling off, use only stainless steel screws to attach.• The provided mounting screws are designed forpanels with a thickness of 5/8" to 3/4". Smaller panelsmay require different mounting hardware to preventdamage to the outside surface.• Failure to construct the custom panel and/or toe kickas instructed on the template may result an improperfit and may prevent the door from closing properly., See the included Custom Panel InstallationTemplate (Dacor PN 100394) for complete installationinstructions and dimensions of the custom panel and ifdesired, a custom toe kick. If the custom cabinet panelrequires decorative door hardware, mount the hardwareon the panel before proceeding to the next step. Forproper door spring operation, the maximum door panelweight, including hardware, is 16 Ibs. (7.3 kg).NOTE: Do not install the toe kick until the dishwasher iscompletely installed and checked for leaks.NOMINAL CUSTOM PANEL DIMENSIONS FOR ID30WIDTH29 7/8" (606 mm)MAXIMUMHEIGHT*30" (762 mm)MAXIMUMTHICKNESS3/4" (19 mm)Dimension without installation of a custom toe kick. Seeincluded template for further details.,,,With the door closed, align the custom panel flush withthe control panel bezel and center it on the door frontframe. Utilize the keyholes to hold the panel.Align the cabinet panel and, using padded clamps,clamp the cabinet panel to the dishwasher front. Slowlylower the door and panel to it's full open position.Attach it to the dishwasher door front utilizing the four(4) mounting holes. Four (4) #10 stainless steel flathead screws are provided for installation of decorativepanels with a thickness of 5/8" to 3/4". The fourmounting holes are located on the inside of the doorframe. Two holes are near the top of the door panel.Two other holes are approximately half way down thedoor panel.If the door springs to do not work properly due to theweight of the panel, adjust the door counterbalance.The counterbalance adjustment screws are located onthe far right side and far left side of the chassis belowthe door.1/2" (13 mm)_!_6 7/8" o(175 mm)18"(457 mm)_-_-7/16" (11 mm)CUSTOM PANEL HOLEALIGNMENTCUSTOM PANEL INSTALLATIONo \J°_ DOORSPRING_ ADJUSTMENT_mCD_ 9