Dacor ED30 Installation Instructions Manual

Also see for Epicure ED30: Use and care manual Planning guide Installation instructions Use and care manual Installation instructions

Contents

Dacor ED30 Installation Instructions Manual Manual pdf 13 page image

Verifying Proper OperationWARNING• To ensure a safe and proper installation, the followingchecklist should be completed by the installer toensure that no part of the installation has beenoverlooked and the unit is working properly.• Proper installation is the responsibility of thehomeowner. The importance of proper installation ofyour Dacor dishwasher cannot be overemphasized.Pre-verification Check List[] Make sure the power plug is disconnected.[] Remove all packing material from inside thedishwasher.[] Check the orientation of the bottom door seal. The seal"bulb" should be facing into the tank. If it is orientedtowards the exterior of the door, open the dishwasherdoor fully and orientate the door seal so that it is facinginto the tank.[][][][]Familiarize yourself with operation of the dishwasher byreading the use and care manual.Remove any protective film, if present from the controlpanel, door panel, etc.Verify that all wiring is secure and is not being pinchedor in contact with door springs or any other dishwashercomponents.Verify that the dishwasher is level by pulling thelower rack half way out. Let go of the rack and makesure it does not roll in or out. If it does, re-level thedishwasher.[][][][]Add two quarts of water to the bottom of thedishwasher to lubricate the pump seal.Turn on the water supply and check for plumbing leaks.Tighten connections if necessary.Verify that the door springs do not come in contact withany dishwasher components.Verify the hot water temperature by turning on thehot water faucet at the sink. The water going to thedishwasher must be between 120 °F and 150 °F.Wet Test Check List[] Plug in the dishwasher power cord.[] Program the dishwasher to run a short wash. See theuse and care manual for specific operating instructions.[] Close the door completely.[][][][][][][]You should hear the dishwasher drain and then beginto fill with water. Wait approximately two (2) minutes,then carefully open the door to verify water is filling thedishwasher tank. If there is water present, close thedoor and continue the process. Should the water notfill the tank or the pump is not running, immediatelypush the START/STOP button to stop the dishwasher.Verify that the water supply valve is turned on, power isconnected, and that main power supply is on.Check for leaks under the dishwasher. If any leaksare found, immediately push the START/STOP buttonand disconnect power. Tighten the water supplyconnections. Reconnect power and restart the cycle.Check for leaks around the door. A leak around thedoor could be caused by the dishwasher door rubbingor hitting against adjacent cabinets. Disconnect powerand reposition and/or re-square the dishwasher ifnecessary. Restart the unit after repositioning.The dishwasher will drain after the first fill. Check thedrain line for leaks. If leaks are found, immediatelypush the START/STOP button and disconnect thepower plug. Tighten the drain connections. Reconnectpower and restart the cycle.Open the dishwasher door and verify that most of thewater has drained. If not, verify that the disposer plughas been removed and/or the air gap is not plugged.Run the dishwasher through another fill and draincycle. Verify that there are no leaks.If the dishwasher does not operate correctly, see theinstructions below.[][]If the fill, wash and drain cycles operate properly,reinstall the toe kick mounting plate. Adjust the toekick to cover legs and snap it into place on the toe kickmounting plate. See page 12 for instructions.Activate the warranty on-line or fill out the warrantycard and mail it.If the dishwasher fails to operate properly:• Verify that power is supplied to the dishwasher.• Check all plumbing connections.• Repeat the above test.• If the appliance still does not work, contact DacorDistinctive Service at (877) 337-3226. Do not attemptto repair the appliance yourself. If you need service, besure to have the model and serial numbers availablewhen you call. See the inside cover for location.Dacor is not responsible for the cost of correcting problemscaused by a faulty installation.ctacor 11

/ 15

Related manuals for Dacor Epicure ED30