10Installation RequirementsCustom HandlesDacor recommends handles with larger D-style pulls. If usingscrews with thick heads, they must be countersunk into the panelbefore installing the handles.Any handle designed for use with an appliance should producesatisfactory results. Mounting screw length varies with the totalthickness of the panels.IMPORTANT: Dacor does not advise the use of single pull knobs.A. Countersunk screwTrim framesurrounding doorB. HandleC. Door panel assemblyDoorBAC20" Typ.(50.8 cm)36" Max.(91.4 cm)Custom Panels and Handles - IF36 Series Models (Continued)Custom Panels Construction InformationSee page 9 for overall dimensions.NOTE: Spacer panels must be at least 1” (2.54 cm) from the top,bottom, and side edges of the backer panel.3-Piece Grille Overlay Panel Configuration3-Piece Door Overlay Panel Configuration1-Piece Overlay Panel ConfigurationIn some cases, your cabinet manufacturer may choose to workwith one panel routed for the different dimensions. Follow thesepanel dimensions and placement instructions to be sure that thecustom overlay panels will fit properly.weiVediSweiVpoTA. Offset dimensionB. 1/4 " (6.25 mm) Backer panelC. 1/8 " (3.18 mm) Spacer panelD. 3/4 " (1.92 cm) Decorativeoverlay panel1"(2.54 cm)DCBAA. Offset dimensionB. 1/4 " (6.25 mm) Backer panelC. 1/8 " (3.18 mm) Spacer panelD. 3/4 " (1.92 cm) Decorative overlay panel1"(2.54 cm)DACB