Dacor EOR Installation Instructions Manual

Also see for EOR series: Use and care manual Installation instructions Installation instructions Use and care manual Planning guide

Contents

Dacor EOR Installation Instructions Manual Manual pdf 14 page image

12Installation InstructionsInstalling the Oven in the CabinetWARNINGFailure to properly install the mounting screws may•result in movement or tipping of the oven during useresulting in personal injury.Do not block the oven air exhaust located at the bot-•tom of the oven. Blocking the intake may result in afire hazard, cabinet damage or poor performance.The wall oven is heavy. Do not attempt to install it in•the cabinet with less than two people.Lift the wall oven up to the cabinet cut out, using the1.upper edge of the cavity opening and the bottom of theoven case side as gripping points. Be certain to take allnecessary safety precautions due to the weight of theappliance.Resting the oven on the cabinet-mounting platform, slide2.the oven into the recessed area until the rear edge ofthe oven frame is flush with the cabinet face and theoven is centered within the cut out. Ensure that theelectrical conduit slides through the opening in thecabinet platform or coils above the oven chassis as theoven is slid into place. The cable must be placed intothe recessed area located along the rear vertical edgeof the oven or coiled above the oven chassis. Do nottrap the appliance cable between the oven case backand the rear wall.Locate the mounting holes in the trim on both sides of3.the oven. There are four (4) holes, two (2) on eachside, for single oven models and six (6) holes for dou-ble oven models.Use a 1/16” drill bit to drill pilot holes in the cabinet4.through all of the trim mounting holes.Install all of the provided #6 screws through the oven5.trim into the cabinet to secure the oven. Do not over-tighten the screws.Mounting Screws:Four (4) for single ovenSix (6) for double ovenGrippingpointGripping point:case bottomboth sides